A1DrugTest.com

This new Integrated Cup II with Adulteration Strip tests for adulterants such as PH, Specific Gravity, and Oxidant in urine specimen. This integrated test cup tests for combination of COC, AMP, mAMP, THC, OPI with pH, Specific Gravity, Oxidants/PCC, Nitrite, Glutaraldehyde, and Creatinine.

Our COC, AMP, mAMP, THC, OPI with pH, Specific Gravity, Oxidants/PCC, Nitrite, Glutaraldehyde, Creatinine Integrated drug test cup II with adulterant test strip is:

   * CLIA waived
   * FDA Approved Tests
   * A simple to administer dip-and-read test designed to detect a specific drug(s) in urine
   * Results are ready in just a few minutes
   * 95% to 98% accurate
   * Set to the SAMSHA Cut-off levels

Click here for Test Directions.
Click Here for Package Insert

A configuration of the One Step -Drug Screen Test Cup consists of combination of Cocaine, Amphetamine, Methamphetamine, Marijuana (THC), Opiate drug analytes. This assay provides only a preliminary analytical test result. A more specific alternate chemical method must be used in order to obtain a confirmed analytical result. Gas chromatography/mass spectrometry (GC/MS) is the preferred confirmatory method. Clinical consideration and professional judgment should be applied to the drug of abuse test result, particularly when preliminary positive results are indicated.

• 
  
  
• Allow Test Card & Urine Specimen to reach room temperature (15-300C) prior to testing.
• 1. When ready to perform the test, remove the test from the pouch or container. Dip test strip into the urine specimen & remove immediately.
• 2. Gently blot the test gently on its side to remove excess urine. Note: It is important to blot the test strip for consistent results.
• 3. Read results in one (1) minute by comparing each pad with the color chart supplied. Do not interpret results after 4 minutes.
• 
  
  
   
• POSITIVE RESULT: One red line appears in the Control (C) region. No line appears in the Test (T) region.
• NEGATIVE RESULT: Two red lines appear. One red line should be in the Control (C) region & another red or pink line should be in the Test (T) region. The shade of the red line in the Test region will vary but it should be considered negative whenever there is even a faint pink line.
• INVALID RESULT: Control (C) line fails to appear. Insufficient specimen volume or Incorrect procedural techniques are the most likely reasons for the Control line failure.
• LIMITATIONS:
• 1. The One Step test Strip provides only a qualitative, preliminary analytical result. A secondary analytical method must be used to obtain a confirmed result. Gas Chromatography/Mass Spectrometry (GC/MS) are the preferred confirmatory methods.
• 2. It is possible that technical or procedural errors, as well as other interfering substances in the urine specimen may cause erroneous results.
• 3. Adulterants, such as bleach and/or alum, in urine specimens may produce erroneous results regardless of the analytical method used. If adulteration is suspected, the test should be repeated with another urine specimen.
• 4. Certain medications/pharmaceuticals/compounds may produce a Positive Result.
• 5. A Positive Result indicates presence of the drug or its metabolites but does not indicate level of intoxication, route of administration or concentration in urine.
• a1 drug test.com products have been found to be highly accurate and are guaranteed against defects in labeling & packaging until the stated expiration date.
• Regardless, a1 drug test.com will not be held accountable/liable for the outcome of ANY result arising from the use of a1 drug test.com products.
• a1 drug test.com sole obligation in the event of ANY damage/result/defect is to replace it with a comparable new test strip product. Except for such replacement, the sale, transfer, or handling of these drug test products are without warranty, condition or liability even though the damage/result/defect is due to negligence or other fault.